Description
All Neo4.X:
New cooling and inductance features that are set up in stages. The first stage is a machined aluminum pole sleeve. This provides better heat wicking and is the first portion of inductance linearizing and reduction. The second stage is a combination of the pole sleeve and an aluminum domed compression cap.
This increases the compression ratio for cooling as well as adds some outstroke inductance reduction. The third stage utilizes the pole sleeve, the compression cap, and a thick aluminum finned extrusion that again lowers and linearizes inductance as well as aids in thermal dissipation. With the third stage we have reduced inductance by almost a factor of 3 over utilizing none of the aluminum.
All leads are stitched in the same pattern and use the bolted terminal block as the original hybrid design. But we have added push terminals that use this same setup with the ability to handle much larger wire and completely removing the multiple solder and crimp points that could introduce unwanted resistance.
NB: Please Note these Particular Subs are available only via special order only.
- Dual 1 and Dual 2 Ohm
- Extra heavy aluminum basket
- Wrap around gasket
- Kraft pulp fiber reinforced cone
- Dual layer wide foam surround
- Standard heavy duty stitched hybrid lead or push/hybrid termination
- 144 tinsel count leads
- FEA optimized motor
- 2750W on up depending on options
- Open column motor design for increased cooling
- 4” diameter 4 layer coil
- Standard heavy duty coils
- N52UH Neo magnets
- 10″ Progressive spiders (options for 3-5 depending on series)
- Water jet and machined in house at Fi
- 3 stage inductance and cooling options
- 33mm Xmax
- 12″, 15″, and 18″sizes
Team Prices Available Click the “Request Team Pricing” Link below and fill out the required information:
Reviews
There are no reviews yet.